ATMEGA8535 Programming Manual

●The ATMEGA8535L-8AU is a high-performance, low-power 8-bit AVR RISC-based Microcontroller combines 8kB of programmable flash memory, 544B SRAM, 512byte EEPROM and an 8-channel 10-bit A/D converter. The device supports throughput of 16MIPS at 16MHz and operates between 4.5 to 5.5V. By executing instructions in a single clock cycle, the device achieves throughputs approaching 1MIPS per MHz, balancing power consumption and processing speed. The device is manufactured using Atmel"s high density nonvolatile memory technology. The on-chip ISP flash allows the program memory to be reprogrammed in-system through an SPI serial interface, by a conventional nonvolatile memory programmer, or by an on-chip boot program running on the AVR core. The boot program can use any interface to download the application program in the application flash memory.

● Advanced RISC architecture

● Power-on reset and programmable brown-out detection

● Internal calibrated RC oscillator

● External and internal interrupt sources

● Six sleep modes - idle, ADC noise reduction, power-save, power-down, standby and extended standby

● 130 Powerful instructions-most single clock cycle execution

● 32 x 8 General purpose working registers

● Fully static operation

● Up to 16MIPS throughput at 16MHz

● On-chip 2-cycle multiplier

● Programmable watchdog timer with separate on-chip oscillator

● On-chip analog comparator

● Two 8-bit timers/counters with separate prescalers and compare modes

● One 16-bit timer/counter with separate prescaler, compare mode and capture mode

● Real-time counter with separate oscillator

● Four PWM channels

● Programmable serial USART

● Master/Slave SPI serial interface