LPC1114 User Reference Manual Guide

●Overview

●The LPC1114FBD48 is an ARM Cortex-M0 microcontroller and it can operate up to 50 MHz. The peripheral complement of the LPC1114FBD48 includes 32 kB of flash memory, 8 kB of data memory, one Fast-mode Plus I²C-bus interface, one RS-485/EIA-485 UART, two SPI interfaces with SSP features, four general purpose counter/timers, a 10-bit ADC, and 42 general purpose I/O pins. In addition, the LPC1114FBD48 features unique on-chip API-driven power profiles which provide users with ready-to-use power management templates. Optimized for CPU performance, CPU efficiency and lowest active current, the power profiles enable maximum operating frequency through the entire voltage range from 1.8 V to 3.6 V without compromising speed or functionality.

●MoreLess

●## Features

● ARM Cortex-M0 processor, running at frequencies of up to 50 MHz

● ARM Cortex-M0 built-in Nested Vectored Interrupt Controller (NVIC)

● Serial Wire Debug

● System tick timer

● 32 kB on-chip flash programming memory

● 8 kB SRAM

● In-System Programming (ISP) and In-Application Programming (IAP)

● 42 General Purpose I/O (GPIO) pins with configurable pull-up/-down resistors

● High-current output driver (20 mA) on one pin

● Programmable WatchDog Timer (WDT)

● 10-bit ADC with input multiplexing among 8 pins

● UART with fractional baud rate generation

● Two SPI controllers with SSP features and FIFO and multi-protocol capabilities

● I²C-bus interface supporting full I²C-bus specification and Fast-mode Plus

● Integrated PMU (Power Management Unit) to minimize power consumption

● Power profiles residing in boot ROM (LPC1100Land LPC1100XL series only)

● Unique device serial number for identification

● Single 3.3 V power supply (1.8 V to 3.6 V)

●## Target Applications

● eMetering

● Alarm systems

● Lighting

● White goods

●## Features