●Overview
●The LPC11U14FBD48 is a ARM Cortex-M0 based, low-cost 32-bit MCU, designed for 8/16-bit microcontroller applications, offering performance, low power, simple instruction set and memory addressing together with reduced code size compared to existing 8/16-bit architectures. The LPC11U14FBD48 operates at CPU frequencies of up to 50 MHz. The peripheral complement of the LPC11U14FBD48 includes up to 32 kB of flash memory, 6 kB of SRAM data memory, a highly flexible and configurable Full Speed USB 2.0 device controller, one Fast-mode Plus I2C-bus interface, one RS-485/EIA-485 USART with support for synchronous mode and smart card interface, one SSP interface, four general purpose counter/timers, a 10-bit ADC, and up to 40 general purpose I/O pins.
●MoreLess
●## Features
● ARM Cortex-M0 processor, running at frequencies of up to 50 MHz
● ARM Cortex-M0 built-in Nested Vectored Interrupt Controller (NVIC)
● Non Maskable Interrupt (NMI) input selectable from several input sources
● System tick timer
● Up to 32 kB on-chip flash program memory
● 6 kB SRAM data memory
● 16 kB boot ROM
● In-System Programming (ISP) and In-Application Programming (IAP)
● Standard JTAG test/debug interface
● Serial Wire Debug
● Boundary scan for simplified board testing
● Up to 40 General Purpose I/O (GPIO) pins
● GPIO pins can be used as edge and level sensitive interrupt sources
● GPIO grouped interrupt module
● High-current source output driver (20 mA) on one pin (P0_7)
● High-current sink driver (20 mA) on true open-drain pins (P0_4 and P0_5)
● Four general purpose counter/timers
● Programmable Windowed WatchDog Timer (WWDT)
● 10-bit ADC with input multiplexing among eight pins
● USB 2.0 full-speed device controller
● USART with fractional baud rate generation
● One SSP controller with FIFO and multi-protocol capabilities
● I2C-bus interface supporting the full I2C-bus specification and Fast-mode Plus
● Crystal Oscillator with an operating range of 1 MHz to 25 MHz
● Internal low-power, low-frequency WatchDog Oscillator (WDO)
● PLL allows CPU operation up to the maximum CPU rate
● A second, dedicated PLL is provided for USB
● Clock output function with divider
● Four reduced power modes: Sleep, Deep-sleep, Power-down, and Deep power-down
● Power profiles residing in boot ROM allowing to optimize performance
● Processor wake-up from Deep-sleep and Power-down modes
● Processor wake-up from Deep power-down mode using one special function pin
● Integrated PMU (Power Management Unit) to minimize power consumption
● Power-On Reset (POR)
● Brownout detect with four separate thresholds for interrupt and forced reset
● Unique device serial number for identification
● Single 3.3 V power supply (1.8 V to 3.6 V)
● Temperature range -40 ºC to +85 ºC
● Pin compatible to the LPC134x series
●## Target Applications
● Consumer peripherals
● Handheld scanners
● Medical
● USB Audio Devices
● Industrial control
●## Features
