●The LTC4007EGN#PBF is a 4A high efficiency standalone Li-ion Battery Charger for 3 or 4-cell lithium-ion batteries. The PWM controller uses a synchronous, quasi-constant frequency, constant off-time architecture that will not generate audible noise even when using ceramic capacitors. Charging current is programmable to ±4% accuracy using a programming resistor. Charging current can also be monitored as a voltage across the programming resistor. The output float voltage is pin programmed for cell count (3/4 cells) and chemistry (4.2/4.1V). A timer, programmed by an external resistor, sets the charge termination time. Charging is automatically restarted when cell voltage falls below 3.9V/cell. If the cell voltage is less than 2.5V, a low-battery indicator asserts and can be used to program a trickle charge current to safely charge depleted batteries. The FAULT pin is also asserted and charging terminates if the low-battery condition persists for more than 1/4 of total charge time.
● Complete charger controller for 3 or 4-cell Lithium-Ion batteries
● High conversion efficiency up to 96%
● Output currents exceeding 4A
● ±0.8% Charging voltage accuracy
● Built-in charge termination for Li-ion batteries
● AC adapter current limiting maximizes charge rate
● Thermistor input for temperature qualified charging
● Wide input voltage range (6 to 28V)
● 0.5V Dropout voltage, 98% maximum duty cycle
● Programmable charge current (±4% accuracy)
● Indicator outputs for charging, C/10 current detection, AC adapter present, low battery
● Charging current monitor output
