MAX211 Datasheet PDF

●The MAX211 device consists of four line drivers, five line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 5-V supply. The devices operate at data signaling rates up to 120 kbit/s and a maximum of 30-V/µs driver output slew rate.

●The MAX211 has both shutdown (SHDN) and enable control (EN)\\. In shutdown mode, the charge pumps are turned off, V+ is pulled down to VCC, V– is pulled to GND, and the transmitter outputs are disabled. This reduces supply current typically to 1 µA. EN\ is used to put the receiver outputs into the high-impedance state to allow wired-OR connection of two RS-232 ports. It has no effect on the RS-232 drivers or the charge pumps.

● RS-232 Bus-Pin ESD Protection Exceeds ±15 kV Using Human-Body Model (HBM)

● Meets or Exceeds the Requirements of TIA/EIA-232-F and ITU v.28 Standards

● Operates at 5-V VCC Supply

● Four Drivers and Five Receivers

● Operates Up To 120 kbit/s

● Low Supply Current in Shutdown Mode... 1 µA Typical

● External Capacitors... 4 × 0.1 µF

● Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II

● Applications

● Battery-Powered Systems, PDAs, Notebooks, Laptops, Palmtop PCs, and Hand-Held Equipment