MAX3221 Datasheet PDF

●The MAX3221 device consists of one line driver, one line receiver with dedicated enable pin, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. These devices operate at data signaling rates up to 250 kbps and a maximum of 30-V/±s driver output slew rate.

●Flexible control options for power management are available when the serial port is inactive. The automatic power-down feature functions when FORCEON is low and FORCEOFF is high. During this mode of operation, if the device does not sense a valid RS-232 signal on the receiver input, the driver output is disabled and the supply current is reduced to 1 µA. The INVALID output notifies the user if an RS-232 signal is present at the receiver input.

● RS-232 Bus-Pin ESD Protection Exceeds

●±15 kV Using Human Body Model (HBM)

● Meets or Exceeds the Requirements of

●TIA/EIA-232-F and ITU V.28 Standards

● Operates With 3-V to 5.5-V VCC Supply

● Operates up to 250 kbps

● One Driver and One Receiver

● Low Standby Current: 1 µA Typical

● External Capacitors: 4 × 0.1 µF

● Accepts 5-V Logic Input With 3.3-V Supply

● Alternative High-Speed Pin-Compatible

●Device (1 Mbps)

● SNx5C3221

● Automatic Power-Down Feature Automatically

●Disables Drivers for Power Savings