●The STM8S005C6/K6 value line 8-bit microcontrollers offer 32 Kbytes Flash program memory, plus 128 bytes of data EEPROM. They are referred to as medium-density devices in the STM8S microcontroller family reference manual (RM0016).
●All devices of STM8S005C6/K6 value line provide the following benefits: performance, robustness, reduced system cost and short development cycles.
●Device performance and robustness are ensured by true data EEPROM supporting up to 100000 write/erase cycles, advanced core and peripherals made in a state-of-the-art technology at 16 MHz clock frequency, robust I/Os, independent watchdogs with separate clock source, and a clock security system.
●The system cost is reduced thanks to a high system integration level with internal clock oscillators, watchdog, and brown-out reset.
●The common family product architecture with compatible pinout, memory map and modular peripherals allow application scalability and reduced development cycles.
●All products operate from a 2.95 V to 5.5 V supply voltage.
●Full documentation is offered as well as a wide choice of development tools.
●Key Features
● Core
● Max fCPU : 16 MHz
● Advanced STM8 core with Harvard architecture and 3-stage pipeline
● Extended instruction set
● Memories
● Medium-density Flash/EEPROM
● Program memory: 32 Kbytes of Flash memory; data retention 20 years at 55 °C after 100 cycles
● Data memory: 128 bytes true data EEPROM; endurance up to 100 k write/erase cycles
● RAM: 2 Kbytes
● Clock, reset and supply management
● 2.95 V to 5.5 operating voltage
● Flexible clock control, 4 master clock sources
● Low-power crystal resonator oscillator
● External clock input
● Internal, user-trimmable 16 MHz RC
● Internal low-power 128 kHz RC
● Clock security system with clock monitor
● Power management
● Low-power modes (wait, active-halt, halt)
● Switch-off peripheral clocks individually
● Permanently active, low-consumption power-on and power-down reset
● Interrupt management
● Nested interrupt controller with 32 interrupts
● Up to 37 external interrupts on 6 vectors
● Timers
● 2x 16-bit general purpose timers, with 2+3 CAPCOM channels (IC, OC or PWM)
● Advanced control timer: 16-bit, 4 CAPCOM channels, 3 complementary outputs, dead-time insertion and flexible synchronization
● 8-bit basic timer with 8-bit prescaler
● Auto wakeup timer
● Window and independent watchdog timers
● Communications interfaces
● UART with clock output for synchronous operation, SmartCard, IrDA, LIN
● SPI interface up to 8 Mbit/s
● I2 C interface up to 400 Kbit/s
● Analog to digital converter (ADC)
● 10-bit ADC, ± 1 LSB ADC with up to 10 multiplexed channels, scan mode and analog watchdog
● I/Os
● Up to 38 I/Os on a 48-pin package including 16 high-sink outputs
● Highly robust I/O design, immune against current injection
● Development support
● Embedded single-wire interface module (SWIM) for fast on-chip programming and non-intrusive debugging
