●The TAS5715 is a 25-W, efficient, digital audio-power amplifier for driving stereo bridge-tied speakers. One serial data input allows processing of up to two discrete audio channels and seamless integration to most digital audio processors and MPEG decoders. The device accepts a wide range of input data and data rates. A fully programmable data path routes these channels to the internal speaker drivers.
●The TAS5715 is a slave-only device receiving all clocks from external sources. The TAS5715 operates with a PWM carrier between a 384-kHz switching rate and a 352-KHz switching rate, depending on the input sample rate. Oversampling combined with a fourth-order noise shaper provides a flat noise floor and excellent dynamic range from 20 Hz to 20 kHz.
● Audio Input/Output
● 25-W Into an 8- Load From an 18-V Supply
● 50-W Support in PBTL Mode With 4- Load
● Wide PVDD Range, From 8 V to 26 V
● Efficient Class-D Operation Eliminates Need for Heatsinks
● Requires Only 3.3 V and PVDD
● One Serial Audio Input (Two Audio Channels)
● I2C Address Selection via PIN (Chip Select)
● Supports 8-kHz to 48-kHz Sample Rate (LJ/RJ/I2S)
● Headphone PWM Outputs
● Dedicated Pin for External Headphone-Amplifier Shutdown
● Single-Filter PBTL Support
● Audio/PWM Processing
● Independent Channel Volume Controls With 24-dB to Mute
● Independent Headphone Volume
● Programmable Two-Band Dynamic Range Control
● Up to Eight User-Programmable Biquads per Channel
● Programmable Coefficients for DRC Filters
● DC Blocking Filters and PWM DC Detect
● CRC Checksum to Detect Biquad Coefficient Corruption
● General Features
● Serial Control Interface Operational Without MCLK
● Factory-Trimmed Internal Oscillator for Automatic Rate Detection
● Surface Mount, 48-Pin, 7-mm × 7-mm HTQFP Package
● Thermal and Short-Circuit Protection
● Benefits
● EQ: Speaker Equalization Improves Audio Performance
● DRC: Automatic Gain Limiter. Can Be Used As Power Limiter.
●Enables Speaker Protection, Easy Listening
● Two-Band DRC: Set Two Different Thresholds for Low- and
●High-Frequency Content
● Autobank Switching: Preload Coefficients for Different
●Sample Rates. No Need to Write New Coefficients to the
●Part When Sample Rate Changes
● Autodetect: Automatically Detects Sample-Rate Changes.
●No Need for External Microprocessor Intervention
● Single-Filter PBTL Support Reduces BOM Cost
● Thgermal Dissipation, Improving System Stability