23K640-I/SN Datasheet PDF - Microchip

The 23K640-I/SN is a 64kb SPI Bus Low-power Serial SRAM memory accessed via a simple serial peripheral interface (SPI) compatible serial bus. The bus signals required are a clock input (SCK) plus separate data in (SI) and data out (SO) lines. Access to the device is controlled through a chip select (CS) input. Communication to the device can be paused via the hold pin (HOLD). While the device is paused, transitions on its inputs will be ignored, with the exception of Chip Select, allowing the host to service higher priority interrupts. It may also interface with microcontrollers that do not have a built-in SPI port by using discrete I/O lines programmed properly in firmware to match the SPI protocol.

● 16MHz Maximum clock

● Low-power CMOS technology

● 3mA at 1MHz Read current

● 4µA at 3.6V Maximum standby current

● 8192 x 8-bit organization

● 32-byte page

● Flexible operating modes - byte read and write, page mode (32-byte page), sequential mode

● Sequential read/write

● High reliability

●ESD sensitive device, take proper precaution while handling the device.