Overview
●The ATmega48P/88P/168P is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega48P/88P/168P achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.
●Features
●• High Performance, Low Power Atmel® AVR® 8-Bit Microcontroller
●• Advanced RISC Architecture
● – 131 Powerful Instructions – Most Single Clock Cycle Execution
● – 32 x 8 General Purpose Working Registers
● – Fully Static Operation
● – Up to 20 MIPS Throughput at 20 MHz
● – On-chip 2-cycle Multiplier
●• High Endurance Non-volatile Memory Segments
● – 4/8/16K Bytes of In-System Self-Programmable Flash progam memory
● – 256/512/512 Bytes EEPROM
● – 512/1K/1K Bytes Internal SRAM
● – Write/Erase Cycles: 10,000 Flash/100,000 EEPROM
● – Data retention: 20 years at 85°C/100 years at 25°C(1)
● – Optional Boot Code Section with Independent Lock Bits In-System Programming by On-chip Boot Program True Read-While-Write Operation
● – Programming Lock for Software Security
●• Peripheral Features
● – Two 8-bit Timer/Counters with Separate Prescaler and Compare Mode
● – One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture Mode
● – Real Time Counter with Separate Oscillator
● – Six PWM Channels
● – 8-channel 10-bit ADC in TQFP and QFN/MLF package Temperature Measurement
● – 6-channel 10-bit ADC in PDIP Package Temperature Measurement
● – Programmable Serial USART
● – Master/Slave SPI Serial Interface
● – Byte-oriented 2-wire Serial Interface (Philips I2C compatible)
● – Programmable Watchdog Timer with Separate On-chip Oscillator
● – On-chip Analog Comparator
● – Interrupt and Wake-up on Pin Change
●• Special Microcontroller Features
● – Power-on Reset and Programmable Brown-out Detection
● – Internal Calibrated Oscillator
● – External and Internal Interrupt Sources
● – Six Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, Standby, and Extended Standby
●• I/O and Packages
● – 23 Programmable I/O Lines
● – 28-pin PDIP, 32-lead TQFP, 28-pad QFN/MLF and 32-pad QFN/MLF
●• Operating Voltage:
● – 1.8 - 5.5V for ATmega48P/88P/168PV
● – 2.7 - 5.5V for ATmega48P/88P/168P
●• Temperature Range:
● – -40°C to 85°C
●• Speed Grade:
● – ATmega48P/88P/168PV: 0 - 4 MHz @ 1.8 - 5.5V, 0 - 10 MHz @ 2.7 - 5.5V
● – ATmega48P/88P/168P: 0 - 10 MHz @ 2.7 - 5.5V, 0 - 20 MHz @ 4.5 - 5.5V
●• Low Power Consumption at 1 MHz, 1.8V, 25°C:
● – Active Mode: 0.3 mA
● – Power-down Mode: 0.1 µA
● – Power-save Mode: 0.8 µA (Including 32 kHz RTC)
