System Overview
●C8051F330/1/2/3/4/5 devices are fully integrated mixed-signal System-on-a-Chip MCUs. Highlighted features are listed below. Refer to Table 1.1 for specific product feature selection.
●• High-speed pipelined 8051-compatible microcontroller core (up to 25 MIPS)
●• In-system, full-speed, non-intrusive debug interface (on-chip)
●• True 10-bit 200 ksps 16-channel single-ended/differential ADC with analog multiplexer
●• 10-bit Current Output DAC
●• Precision programmable 25 MHz internal oscillator
●• Up to 8 kB of on-chip Flash memory—512 bytes are reserved
●• 768 bytes of on-chip RAM
●• SMBus/I2C, Enhanced UART, and Enhanced SPI serial interfaces implemented in hardware
●• Four general-purpose 16-bit timers
●• Programmable Counter/Timer Array (PCA) with three capture/compare modules and Watchdog Timer function
●• On-chip Power-On Reset, VDD Monitor, and Temperature Sensor
●• On-chip Voltage Comparator
●• 17 Port I/O (5 V tolerant)
●Analog Peripherals
● - 10-Bit ADC (‘F330/2/4 only)
● • Up to 200 ksps
● • Up to 16 external single-ended or differential inputs
● • VREF from internal VREF, external pin or VDD
● • Internal or external start of conversion source
● • Built-in temperature sensor
● - 10-Bit Current Output DAC (‘F330 only)
● - Comparator
● • Programmable hysteresis and response time
● • Configurable as interrupt or reset source
● • Low current (0.4 µA)
●On-Chip Debug
● - On-chip debug circuitry facilitates full speed, nonintrusive in-system debug (no emulator required)
● - Provides breakpoints, single stepping, inspect/modify memory and registers
● - Superior performance to emulation systems using ICE-chips, target pods, and sockets
● - Low cost, complete development kit
●Supply Voltage 2.7 to 3.6 V
● - Typical operating current: 6.4 mA at 25 MHz;
● 9 µA at 32 kHz
● - Typical stop mode current: 0.1 µA
●Temperature Range: –40 to +85 °C
●High Speed 8051 µC Core
● - Pipelined instruction architecture; executes 70% of instructions in 1 or 2 system clocks
● - Up to 25 MIPS throughput with 25 MHz clock
● - Expanded interrupt handler Memory
● - 768 bytes internal data RAM (256 + 512)
● - 8 kB (‘F330/1), 4 kB (‘F332/3), or 2 kB (‘F334/5) Flash; In-system programmable in 512-byte Sectors—512 bytes are reserved in the 8 kB devices
●Digital Peripherals
● - 17 Port I/O; All 5 V tolerant with high sink current
● - Hardware enhanced UART, SMBus™, and enhanced SPI™ serial ports
● - Four general purpose 16-bit counter/timers
● - 16-Bit programmable counter array (PCA) with three capture/compare modules
● - Real time clock mode using PCA or timer and external clock source
●Clock Sources
● - Two internal oscillators:
● • 24.5 MHz with ±2% accuracy supports crystal-less UART operation
● • 80/40/20/10 kHz low frequency, low power
● - External oscillator: Crystal, RC, C, or clock (1 or 2 pin modes)
● - Can switch between clock sources on-the-fly; useful in power saving modes
●20-Pin QFN Package
