The DRV841x2 are high-performance, integrated dual full-bridge motor driver with an advanced protection system.
●Because of the low RDS(on) of the H-Bridge MOSFETs and intelligent gate drive design, the efficiency of these motor drivers can be up to 97%. This high efficiency enables the use of smaller power supplies and heatsinks, and the devices are good candidates for energy-efficient applications.
●The DRV841x2 requires two power supplies, one at 12 V for GVDD and VDD, and another up to 50 V for PVDD. The DRV841x2 can operate at up to 500-kHz switching frequency while still maintaining precise control and high efficiency. The devices also have an innovative protection system safeguarding the device against a wide range of fault conditions that could damage the system. These safeguards are short-circuit protection, overcurrent protection, undervoltage protection, and two-stage thermal protection. The DRV841x2 has a current-limiting circuit that prevents device shutdown during load transients such as motor start-up. A programmable overcurrent detector allows adjustable current limit and protection level to meet different motor requirements.
●The DRV841x2 has unique independent supply and ground pins for each half-bridge. These pins make it possible to provide current measurement through external shunt resistor and support multiple motors with different power supply voltage requirements.
● High-Efficiency Power Stage (up to 97%) With
●Low RDS(on) MOSFETs (110 mΩ at TJ = 25°C)
● Operating Supply Voltage up to 52 V
● DRV8412 (Power Pad Down): up to 2 × 3-A Continuous
●Output Current (2 × 6-A Peak) in Dual Full-Bridge
●Mode or 6-A Continuous Current in Parallel Mode
●(12-A Peak)
● DRV8432 (Power Pad Up): up to 2 × 7-A Continuous
●Output Current (2 × 12-A Peak) in Dual Full-Bridge
●Mode or 14-A Continuous Current in Parallel Mode
●(24-A Peak)
● PWM Operating Frequency up to 500 kHz
● Integrated Self-Protection Circuits Including Undervoltage,
●Overtemperature, Overload, and Short Circuit
● Programmable Cycle-by-Cycle Current Limit Protection
● Independent Supply and Ground Pins for Each Half Bridge
● Intelligent Gate Drive and Cross Conduction Prevention
● No External Snubber or Schottky Diode is Required
● APPLICATIONS
● Brushed DC and Stepper Motors
● Three-Phase Permanent Magnet Synchronous Motors
● Robotic and Haptic Control System
● Actuators and Pumps
● Precision Instruments
● TEC Drivers
● LED Lighting Drivers
●All other trademarks are the property of their respective owners
