The DSPIC30F4013-30I/P is a motor control 16-bit Digital Signal Controller with seamless migration options from this device to DSPIC33F and PIC24 devices in similar packages. Enhanced flash program memory, 10,000 erase/write cycle (minimum) for industrial temperature range, 100k (typical). Data EEPROM memory, 100,000 erase/write cycle (minimum) for industrial temperature range, 1M (typical). Data converter interface (DCI) supports common audio codec protocols, including I²S and AC"97. The CMOS technology features a low power consumption, high speed flash technology and wide operating voltage range (2.5 to 5.5V).
● Modified Harvard architecture
● C compiler optimized instruction set architecture
● 84 base instructions with flexible addressing modes
● Modulo and bit-reversed addressing modes
● Two, 40-bit wide accumulators with optional saturation logic
● 17-bit x 17-bit single cycle hardware fractional/integer multiplier
● Single cycle multiply-accumulate (MAC) operation
● 40-stage Barrel shifter
● Dual data fetch
● High current sink/source I/O pins (25mA/25mA)
● Optionally pair up 16-bit timers into 32-bit timer modules
● 3-wire SPI™ modules (supports 4 frame modes)
● I²C™ module supports multi-master/slave mode and 7-bit/10-bit addressing
● Addressable UART modules with FIFO buffers and selectable pins
● 12-bit 200ksps Analog-to-digital converter (A/D)
● A/D conversion available during sleep and idle
● 1 Sample/hold
● Multiple conversion sequencing options
● Self-reprogrammable under software control
● Fail-safe clock monitor operation
●ESD sensitive device, take proper precaution while handling the device.