GENERAL DESCRIPTION
●The EN25F80 is an 8M-bit (1024K-byte) Serial Flash memory, with advanced write protection mechanisms, accessed by a high speed SPI-compatible bus. The memory can be programmed 1 to 256 bytes at a time, using the Page Program instruction.
●The EN25F80 is designed to allow either single Sector/Block at a time or full chip erase operation. The EN25F80 can be configured to protect part of the memory as the software protected mode. The device can sustain a minimum of 100K program/erase cycles on each sector or block.
●FEATURES
●· Single power supply operation
●- Full voltage range: 2.7-3.6 volt
●· Serial Interface Architecture
●- SPI Compatible: Mode 0 and Mode 3
●· 8 Mbit Serial Flash
●- 8 M-bit/1024 K-byte/4096 pages
●- 256 bytes per programmable page
●· High performance
●- 100MHz clock rate
●· Low power consumption
●- 12 mA typical active current
●- 1 mA typical power down current
●· Uniform Sector Architecture:
●- 256 sectors of 4-Kbyte
●- 16 blocks of 64-Kbyte
●- Any sector or block can be erased individually
●· Software and Hardware Write Protection:
●- Write Protect all or portion of memory via software
●- Enable/Disable protection with WP# pin
●· High performance program/erase speed
●- Page program time: 1.3ms typical
●- Sector erase time: 90ms typical
●- Block erase time 500ms typical
●- Chip erase time: 8 seconds typical
●· Lockable 256 byte OTP security sector
●· Minimum 100K endurance cycle
●· Package Options
●- 8 pins SOP 150mil body width
●- 8 pins SOP 200mil body width
●- 8 contact VDFN
●- 8 pins PDIP
●- All Pb-free packages are RoHS compliant
●· Commercial and industrial temperature Range
