The LM3508 is a synchronous boost converter (no external Schottky diode required) that provides a constant current output. It is designed to drive up to 4 series white LEDs at 30mA from a single-cell Li-Ion battery. A single low power external resistor is used to set the maximum LED current. The LED current can be adjusted by applying a PWM signal of up to 100kHz to the DIM pin. Internal soft-start circuitry is designed to eliminate high in-rush current at start-up. For maximum safety, the device features an advanced short-circuit protection when the output is shorted to ground. Additionally, over-voltage protection and an 850kHz switching frequency allow for the use of small, low-cost output capacitors with lower voltage ratings. During shutdown, the output is disconnected from the input preventing a leakage current path through the LEDs to ground. The LM3508 is available in a tiny 9-bump chip-scale DSBGA package.
● Drives 4 Series White LEDs with up to 30mA
● >80% Peak Efficiency
● Up to 100kHz PWM Brightness Control
● Accurate ±5% LED Current Regulation across VIN range
● Internal Synchronous PFET (No Schottky Diode Required)
● True Shutdown Isolation
● Output Short-Circuit Protection
● 17.5V Over-Voltage Protection
● Internal Soft-Start Eliminates Inrush Current
● Wide Input Voltage Range: 2.7V to 5.5V
● 850kHz Fixed Frequency Operation
● Low Profile 9-Bump DSBGA Package (1.514mm x 1.514mm x 0.6mm)
●All trademarks are the property of their respective owners.
