The LM5046 PWM controller contains all of the features necessary to implement a phase-shifted full-bridge topology power converter using either current mode or voltage mode control. This device is intended to operate on the primary side of an isolated DC-DC converter with input voltage up to 100 V. This highly integrated controller-driver provides dual 2-A high- and low-side gate drivers for the four external bridge MOSFETs, plus control signals for the secondary-side synchronous rectifier MOSFETs. External resistors program the dead-time to enable zero-volt switching of the primary FETs. Intelligent startup of the synchronous rectifiers allows monotonic turnon of the power converter even with prebias load conditions. Additional features include cycle-by-cycle current limiting, hiccup mode restart, programmable soft-start, synchronous rectifier soft-start, and a 2-MHz capable oscillator with synchronization capability and thermal shutdown.
● Highest Integration Controller for Small
●Form Factor, High-Density Power Converters
● High-Voltage Start-Up Regulator
● Intelligent Sync Rectifier Start-Up Allows
●Linear Turn-on into Prebiased Loads
● Synchronous Rectifiers Disabled in UVLO Mode
●and Hiccup Mode
● Two Independent, Programmable Dead-Time
●Adjustments to Enable Zero-Volt Switching
● Four High-Current 2-A Bridge Gate Drivers
● Wide-Bandwidth Opto-Coupler Interface
● Configurable for Either Current Mode or Voltage
●Mode Control
● Dual-Mode Overcurrent Protection
● Resistor Programmed 2-MHz Oscillator
● Programmable Line UVLO and OVP
