Overview
●The LPC1114JHN33 is an ARM Cortex-M0 microcontroller and it can operate up to 50 MHz. The peripheral complement of the LPC1114JHN33 includes 32 kB of flash memory, up to 8 kB of data memory, one Fast-mode Plus I²C-bus interface, one RS-485/EIA-485 UART, one SPI interface with SSP features, four general purpose counter/timers, a 10-bit ADC, and 28 general purpose I/O pins. In addition, the LPC1114JHN33 features unique on-chip API-driven power profiles which provide users with ready-to-use power management templates. Optimized for CPU performance, CPU efficiency and lowest active current, the power profiles enable maximum operating frequency through the entire voltage range from 1.8 V to 3.6 V without compromising speed or functionality.
●MoreLess
●## Features
● ARM Cortex-M0 processor, running at frequencies of up to 50 MHz
● ARM Cortex-M0 built-in Nested Vectored Interrupt Controller (NVIC)
● Serial Wire Debug
● System tick timer
● 32 kB on-chip flash programming memory
● 8 kB SRAM (LPC1114FHN33/30x)
● 4 kB SRAM (LPC1114FHN33/20x)
● In-System Programming (ISP) and In-Application Programming (IAP)
● 28 General Purpose I/O (GPIO) pins with configurable pull-up/-down resistors
● High-current output driver (20 mA) on one pin
● Programmable WatchDog Timer (WDT)
● 10-bit ADC with input multiplexing among 8 pins
● UART with fractional baud rate generation
● One SPI controller with SSP features and FIFO and multi-protocol capabilities
● I²C-bus interface supporting full I²C-bus specification and Fast-mode Plus
● Integrated PMU (Power Management Unit) to minimize power consumption
● Power profiles residing in boot ROM (LPC1100Land LPC1100XL series only)
● Unique device serial number for identification
● Single 3.3 V power supply (1.8 V to 3.6 V)
●## Target Applications
● eMetering
● Alarm systems
● Lighting
● White goods
●## Features
