General description
●The LPC2114/LPC2124 are based on a 16/32 bit ARM7TDMI-S™ CPU with real-time emulation and embedded trace support, together with 128/256 kilobytes (kB) of embedded high speed flash memory. A 128-bit wide memory interface and a unique accelerator architecture enable 32-bit code execution at maximum clock rate. For critical code size applications, the alternative 16-bit Thumb™ Mode reduces code by more than 30 % with minimal performance penalty.
●Features
●Key features
●■ 16/32-bit ARM7TDMI-S microcontroller in a tiny LQFP64 package.
●■ 16 kB on-chip Static RAM.
●■ 128/256 kB on-chip Flash Program Memory. 128-bit wide interface/accelerator enables high speed 60 MHz operation.
●■ In-System Programming (ISP) and In-Application Programming (IAP) via on-chip boot-loader software. Flash programming takes 1 ms per 512 byte line. Single sector or full chip erase takes 400 ms.
●■ EmbeddedICE-RT interface enables breakpoints and watch points. Interrupt service routines can continue to execute whilst the foreground task is debugged with the on-chip RealMonitor™ software.
●■ Embedded Trace Macrocell™ enables non-intrusive high speed real-time tracing of instruction execution.
●■ Four channel 10-bit A/D converter with conversion time as low as 2.44 µs.
●■ Two 32-bit timers (with 4 capture and 4 compare channels), PWM unit (6 outputs), Real Time Clock and Watchdog.
●■ Multiple serial interfaces including two UARTs (16C550), Fast I2C (400 kbits/s) and two SPIs™.
●■ 60 MHz maximum CPU clock available from programmable on-chip Phase-Locked Loop with settling time of 100 µs.
●■ Vectored Interrupt Controller with configurable priorities and vector addresses.
●■ Up to forty-six 5 V tolerant general purpose I/O pins. Up to nine edge or level sensitive external interrupt pins available.
●■ On-chip crystal oscillator with an operating range of 1 MHz to 30 MHz.
●■ Two low power modes, Idle and Power-down.
●■ Processor wake-up from Power-down mode via external interrupt.
●■ Individual enable/disable of peripheral functions for power optimization.
●■ Dual power supply:
● ◆ CPU operating voltage range of 1.65 V to 1.95 V (1.8 V ±0.15 V).
● ◆ I/O power supply range of 3.0 V to 3.6 V (3.3 V ± 10 %) with 5 V tolerant I/O pads.16/32-bit ARM7TDMI-S processor.
