The MAX17085BETL+ is an integrated charger, dual main step-down controller and dual LDO regulator in 40 pin TQFN package. It is an all-in-one notebook power solution integrating a multichemistry battery charger, dual fixed output Quick-PWM step-down controllers and dual keep-alive linear regulators. The high-frequency 1.4MHz multichemistry battery charger uses a current-mode, fixed inductor current ripple architecture. Low-offset sense amplifiers allow the use of low-value sense resistors for charging and input current limit. The dual Quick-PWM step-down controllers with synchronous rectification generate the 5V and 3.3V main power in a notebook. Low side MOSFET sensing provides a simple low-cost, highly efficient valley current-limit protection. An internal 5V/100mA LDO5 with switchover can be used to either generate the 5V bias needed for power-up or other lower power "always-on" suspend supplies. Another 3.3V/50mA LDO3 provides "always-on" power to a system microcontroller.
● AC adapter overvoltage and overcurrent protection
● Operating temperature range from -40°C to 85°C
● Dual quick PWM with fast transient response and extended on-time
● Switching frequency is 300KHz to 800KHz
● Low noise ultrasonic mode
● Autoretry fault protection
● Automatic selection of system power source
● Internal charge pump for adapter n-channel MOSFETs drive
● Monitor o/ps for AC adapter current (±2% accuracy), battery discharge current (±2% accuracy)
● Analogue/PWM (100Hz to 500KHz) adjustable charge current setting
