The MC9S08DZ60AMLF is a 8-bit Embedded CAN Microcontroller based on enhanced HCS08 CPU (20MHz bus) with CISC architecture operates at a maximum frequency of 40MHz. The device incorporates 60kB internal flash, 4kB internal RAM, an analog comparator, a can, 16-channel 12-bit A/D converter and 40 general-purpose I/O pins. This device also features peripherals like multi-scalable controller area networks (MSCAN) CAN 2.0 A/B software compatible module, one inter-integrated circuit (IIC) bus module to operate at up to 100kbps, one serial peripheral interface modules (SPI), two serial communications interface (SCI) modules and real-time counter (RTC).
● HC08 Instruction set with added BGND instruction
● Support for up to 32 Interrupt/reset sources
● Two very low power stop modes
● Reduced power wait mode
● Very low power real time interrupt for use in run, wait and stop
● Loop-control Pierce oscillator (XOSC)
● Multi-purpose clock generator (MCG)
● Watchdog computer operating properly (COP) reset
● Low-voltage detection with reset or interrupt - selectable trip points
● Illegal opcode detection with reset
● Illegal address detection with reset
● Flash block protect
● Loss-of-lock protection
● MSCAN - CAN protocol version 2.0 A, B
● Two SCIs supporting LIN 2.0 protocol and SAE J2602 protocols
● 24 Interrupt pins with selectable polarity on each pin
● Hysteresis and configurable pull device on all input pins
● Configurable slew rate and drive strength on all output pins
● Single-wire background debug interface
● On-chip, in-circuit emulation (ICE) with real-time bus capture
