The PIC16F886-I/SP is a 8-bit flash-based CMOS Microcontroller. It features 256bytes of EEPROM data memory, self programming, an ICD, 2 comparators, 11 channels of 10-bit Analogue-to-Digital (A/D) converter, 1 capture/compare/PWM and 1 Enhanced capture/compare/PWM functions, a synchronous serial port that can be configured as either 3-wire serial peripheral interface (SPI™) or the 2-wire inter-integrated circuit (I²C™) bus and an enhanced universal asynchronous receiver transmitter (EUSART). The Analogue-to-Digital converter (ADC) allows conversion of an analogue input signal to a 10-bit binary representation of that signal. This device uses analogue inputs, which are multiplexed into a single sample and hold circuit. The output of the sample and hold is connected to the input of the converter. The converter generates a 10-bit binary result via successive approximation and stores the conversion result into the ADC result registers (ADRESL and ADRESH).
● Software selectable frequency range of 8MHz to 32kHz
● Fail-safe clock monitoring for critical applications
● Clock mode switching during operation for low-power operation
● Power-saving sleep mode
● Power-on reset (POR)
● Selectable brown-out reset (BOR) voltage
● Extended watchdog timer (WDT) with its own on-chip RC oscillator for reliable operation
● In-circuit serial Programming™ (ICSP™) via two pins
● In-circuit debug (ICD) via two pins
● High-endurance flash/EEPROM cell
● Self-reprogrammable under software control
● Programmable code protection
● Capture/compare/PWM (CCP) module
● Enhanced capture/compare/PWM (ECCP) module with auto-shutdown and PWM steering
● Master synchronous serial port (MSSP) module SPI™ mode, I²C™ mode with address mask capability
●ESD sensitive device, take proper precaution while handling the device.