● Includes NXP’s intellectual property licensing rights (required for ISO/IEC14443A implementation)
● Fast and cost-efficient NFC design startup
● Highly integrated analog circuitry to demodulate and decode responses
● Buffered output drivers for connecting an antenna with the minimum number of external components
● Integrated RF Level detector
● Integrated data mode detector
● Supports ISO/IEC 14443 A/MIFARE
● Supports ISO/IEC 14443 B Read/Write modes
● Typical operating distance in Read/Write mode up to 50 mm depending on the antenna size and tuning
● Typical operating distance in NFCIP-1 mode up to 50 mm depending on the antenna size and tuning and power supply
● Typical operating distance in ISO/IEC 14443A/MIFARE card or FeliCa Card Operation mode of about 100 mm depending on the antenna size and tuning and the external field strength
● Supports MIFARE Classic encryption in Reader/Writer mode
● ISO/IEC 14443A higher transfer speed communication at 212 kbit/s and 424 kbit/s
● Contactless communication according to the FeliCa scheme at 212 kbit/s and 424 kbit/s
● Integrated RF interface for NFCIP-1 up to 424 kbit/s
● S²C interface
● Additional power supply to directly supply the smart card IC connected via S²C
● Supported host interfaces:
● SPI up to 10 Mbit/s
● I²C-bus interface up to 400 kBd in Fast mode, up to 3400 kBd in High-speed mode
● RS232 Serial UART up to 1228.8 kBd, with voltage levels dependant on pin voltage supply
● 8-bit parallel interface with and without Address Latch Enable
● FIFO buffer handles 64 byte send and receive
● Flexible interrupt modes
● Hard reset with low power function
● Power-down mode per software
● Programmable timer
● Internal oscillator for connection to 27.12 MHz quartz crystal
● 2.5 V to 3.6 V power supply
● CRC coprocessor
● Programmable I/O pins
● Internal self-test
