This 16-bit (dual-octal) noninverting bus transceiver contains two separate supply rails. B port has VCCB, which is set to operate at 3.3 V and 5 V. A port has VCCA, which is set to operate at 2.5 V and 3.3 V. This allows for translation from a 2.5-V to a 3.3-V environment, and vice versa, or from a 3.3-V to a 5-V environment, and vice versa.
●The SN74ALVC164245 is designed for asynchronous communication between data buses. The control circuitry (1DIR, 2DIR, 1OE, and 2OE) is powered by VCCA.
●To ensure the high-impedance state during power up or power down, the output-enable (OE) input should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
●The logic levels of the direction-control (DIR) input and the output-enable (OE) input activate either the B-port outputs or the A-port outputs or place both output ports into the high-impedance mode. The device transmits data from the A bus to the B bus when the B-port outputs are activated, and from the B bus to the A bus when the A-port outputs are activated. The input circuitry on both A and B ports always is active and must have a logic HIGH or LOW level applied to prevent excess ICC and ICCZ.
● Member of the Texas Instruments Widebus™ Family
● Maximum tpd of 5.8 ns at 3.3 V
● ±24-mA Output Drive at 3.3 V
● Control Inputs VIH/VIL Levels Are Referenced to VCCA Voltage
● Latch-Up Performance Exceeds 250 mA Per JESD 17
● APPLICATIONS
● Electronic Points of Sale
● Printers and Other Peripherals
● Motor Drives
● Wireless and Telecom Infrastructures
● Wearable Health and Fitness Devices
●All other trademarks are the property of their respective owners