SN74CB3Q32245 Datasheet PDF - TI

The SN74CB3Q32245 is a high-bandwidth FET bus switch utilizing a charge pump to elevate the gate voltage of the pass transistor, providing a low and flat ON-state resistance (ron). The low and flat ON-state resistance allows for minimal propagation delay and supports rail-to-rail switching on the data input/output (I/O) ports. The device also features low data I/O capacitance to minimize capacitive loading and signal distortion on the data bus. Specifically designed to support high-bandwidth applications, the SN74CB3Q32245 provides an optimized interface solution ideally suited for broadband communications, networking, and data-intensive computing systems.

●The SN74CB3Q32245 is organized as four 8-bit bus switches with separate output-enable (1OE\, 2OE\, 3OE\, 4OE\\) inputs. It can be used as four 8-bit bus switches, two 16-bit bus switches, or as one 32-bit bus switch. When OE\ is low, the associated 8-bit bus switch is ON and the A port is connected to the B port, allowing bidirectional data flow between ports. When OE\ is high, the associated 8-bit bus switch is OFF, and a high-impedance state exists between the A and B ports.

●This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry prevents damaging current backflow through the device when it is powered down. The device has isolation during power off.

●To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

● Member of the Texas Instruments Widebus+™ Family

● High-Bandwidth Data Path (Up to 500 MHz)

● 5-V-Tolerant I/Os with Device Powered Up or Powered Down

● Low and Flat ON-State Resistance (ron) Characteristics Over Operating Range (ron = 5 Typical)

● Rail-to-Rail Switching on Data I/O Ports

● 0- to 5-V Switching With 3.3-V VCC

● 0- to 3.3-V Switching With 2.5-V VCC

● Bidirectional Data Flow, With Near-Zero Propagation Delay

● Low Input/Output Capacitance Minimizes Loading and Signal Distortion (Cio(OFF) = 4 pF Typical)

● Fast Switching Frequency (fOE\ = 20 MHz Max)

● Data and Control Inputs Provide

●Undershoot Clamp Diodes

● Low Power Consumption (ICC = 2 mA Typical)

● VCC Operating Range From 2.3 V to 3.6 V

● Data I/Os Support 0- to 5-V Signaling Levels (0.8 V, 1.2 V, 1.5 V, 1.8 V, 2.5 V, 3.3 V, 5 V)

● Control Inputs Can be Driven by TTL or 5-V/3.3-V CMOS Outputs

● Ioff Supports Partial-Power-Down Mode Operation

● Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II

● ESD Performance Tested Per JESD 22

● 2000-V Human-Body Model (A114-B, Class II)

● 1000-V Charged-Device Model (C101)

● Supports Both Digital and Analog Applications: PCI Interface, Differential Signal Interface, Memory Interleaving, Bus Isolation, Low-Distortion Signal Gating

●For additional information regarding the performance characteristics of the CB3Q family, refer to the TI application report, CBT-C, CB3T, and CB3Q Signal-Switch Families, literature number SCDA008.

●Widebus+ is a trademark of Texas Instruments.