The ST92F124/F150/F250 microcontroller is developed and manufactured by STMicroelectronics using a proprietary n-well HCMOS process. Its performance derives from the use of a flexible 256-register programming model for ultra-fast context switching and real-time event response. The intelligent on-chip peripherals offload the ST9 core from I/O and data management processing tasks allowing critical application tasks to get the maximum use of core resources. The new-generation ST9 MCU devices now also support low power consumption and low voltage operation for power-efficient and low-cost embedded systems.
●Key Features
● Memories
● Internal memory: Single Voltage Flash up to 256 Kbytes, RAM up to 8 Kbytes, 1 Kbyte E3 TM (Emulated EEPROM)
● In-Application Programming (IAP)
● 224 general purpose registers (register file) available as RAM, accumulators or index pointers
● Clock, reset and supply management
● Register-oriented 8/16 bit CORE with RUN, WFI, SLOW, HALT and STOP modes
● 0-24 MHz Operation (Int. Clock), 4.5-5.5 V range
● PLL Clock Generator (3-5 MHz crystal)
● Minimum instruction time: 83 ns (24 MHz int. clock)
● Up to 80 I/O pins
● Interrupt management
● 4 external fast interrupts + 1 NMI
● Up to 16 pins programmable as wake-up or additional external interrupt with multi-level interrupt handler
● DMA controller for reduced processor overhead
● Timers
● 16-bit Timer with 8-bit Prescaler, and Watchdog Timer (activated by software or by hardware)
● 16-bit Standard Timer that can be used to generate a time base independent of PLL Clock Generator
● Two 16-bit independent Extended Function Timers (EFTs) with Prescaler, up to two Input Captures and up to two Output Compares
● Two 16-bit Multifunction Timers, with Prescaler, up to two Input Captures and up to two Output Compares
● Communication interfaces
● Serial Peripheral Interface (SPI) with selectable Master/Slave mode
● One Multiprotocol Serial Communications Interface with asynchronous and synchronous capabilities
● One asynchronous Serial Communications Interface with 13-bit LIN Synch Break generation capability
● J1850 Byte Level Protocol Decoder (JBLPD)
● Up to two full I²C multiple Master/Slave Interfaces supporting Access Bus
● Up to two CAN 2.0B Active interfaces
● Analog peripheral (low current coupling)
● 10-bit A/D Converter with up to 16 robust input channels
● Development tools
● Free High performance development environment (IDE) based on Visual Debugger, Assembler, Linker, and C-Compiler; Real Time Operating System (OSEK OS, CMX) and CAN drivers
● Hardware emulator and Flash programming board for development and ISP Flasher for production
