Overview
●The TDA8024 is a complete and cost-efficient analog interface for asynchronous 3 V or 5 V smart cards. It can be placed between the card and the microcontroller to perform all supply, protection and control functions. Very few external components are required. The TDA8024AT is a direct replacement for the TDA8004AT.
●More information can be obtained from the NXP internet site (www.nxp.com) and from _“Application note AN10141”_.
●MoreLess
●## Features
● IC card interface
● 3 or 5 V supply for the IC (VDD and GND)
● Three specifically protected half-duplex bidirectional buffered I/O lines to card contacts C4, C7 and C8
● DC/DC converter for VCC generation separately powered from a 5 V +- 20 pct supply (VDDP and PGND)
● 3 or 5 V +- 5 pct regulated card supply voltage ((VCC) with appropriate decoupling has the following capabilities:
● ICC< 80 mA at VDDP = 4 to 6.5 V
● Handles current spikes of 40 nAs up to 20 MHz
● Controls rise and fall times
● Filtered overload detection at approximately 120 mA
● Thermal and short-circuit protection on all card contacts
● Automatic activation and deactivation sequences; initiated by software or by hardware in the event of a short-circuit, card take-off, overheating, VDD or VDDP drop-out
● Enhanced ESD protection on card side (>6 kV)
● 26 MHz integrated crystal oscillator
● Clock generation for cards up to 20 MHz (divided by 1, 2, 4 or 8 through CLKDIV1 and CLKDIV2 signals) with synchronous frequency changes
● Non-inverted control of RST via pin RSTIN
● ISO 7816, GSM11.11 and EMV (payment systems) compatibility
● Supply supervisor for spike-killing during power-on and power-off and Power-on reset (threshold fixed internally or externally by a resistor bridge); not for TDA8024AT
● Built-in debounce on card presence contacts
● One multiplexed status signal OFF.
●## Target Applications
● IC card readers for banking
● Electronic payment
● Identification
● Pay TV.
●## Features