Overview
●The TDF8599 is a dual Bridge-Tied Load (BTL) car audio amplifier comprising an NDMOST-NDMOST output stage based on SOI BCDMOS technology. Low power dissipation enables the TDF8599 high-efficiency, class-D amplifier to be used with a smaller heat sink than those normally used with standard class-AB amplifiers.
●The TDF8599 can operate in either non-I2C-bus mode or I2C-bus mode. When in I2C-bus mode, DC load detection results and fault conditions can be easily read back from the device. Up to five I2C-bus addresses can be selected depending on the value of the external resistor connected to pins ADS and MOD.
●When pin ADS is short circuited to pin AGND, the TDF8599 operates in non-I2C-bus mode. Switching between Operating mode and Mute mode in non-I2C-bus mode is only possible using pins EN and SEL_MUTE.
●MoreLess
●## Features
● High-efficiency
● Low quiescent current
● Operating voltage from 8 V to 18 V
● Two 4 Ω/2 Ω capable BTL channels or one 1 Ω capable BTL channel
● Differential inputs
● Supports I2C-bus mode with five I2C-bus addresses or non-I2C-bus mode operation
● Clip detect
● Independent short circuit protection for each channel
● Advanced short circuit protection for load, GND and supply
● Load dump protection
● Thermal foldback and thermal protection
● DC offset protection
● Selectable AD or BD modulation
● Parallel channel mode for high current drive capability
● Advanced clocking:
● Switchable oscillator clock source: internal for Master mode or external for Slave mode
● Spread spectrum mode
● Phase staggering
● Frequency hopping
● No pop noise caused by DC output offset voltage
●## Target Applications
● I2C-bus mode:
● DC load detection
● AC load detection
● Thermal pre-warning diagnostic level setting
● Identification of activated protections or warnings
● Selectable diagnostic information available using pin DIAG and pin CLIP
● Qualified in accordance with AEC-Q100
●## Features
