The TNY275PG is an energy-efficient offline Switcher incorporates a 700V power MOSFET, oscillator, high voltage switched current source, current limit and thermal shutdown circuitry. It uses an ON/OFF control scheme and offers a design flexible solution with a low system cost and extended power capability. TinySwitch-III combines a high voltage power MOSFET switch with a power supply controller in one device. Unlike conventional PWM controllers, it uses a simple ON/OFF control to regulate the output voltage. The controller consists of an oscillator and enables circuit, current limit state machine, 5.85V regulator, BYPASS/MULTI-FUNCTION pin undervoltage, overvoltage circuit and current limit selection circuitry, over-temperature protection, current limit circuit, leading edge blanking. TinySwitch-III incorporates additional circuitry for line undervoltage sense, auto-restart, adaptive switching cycle on-time extension and frequency jitter.
● Simple ON/OFF control, no loop compensation needed
● Selectable current limit through BP/M capacitor value
● Higher current limit extends peak power/in open frame, continuous power
● Lower current limit improves efficiency in enclosed adapters/chargers
● Allows optimum TinySwitch-III choice by swapping devices with no other circuit redesign
● Maximizes MOSFET and magnetic power delivery
● ON-time extension - Extends low line regulation range/hold-up time to reduce input bulk capacitance
● Self-biased - No bias winding or bias components
● Frequency jittering reduces EMI filter
● Pin-out simplifies heat sinking to the PCB
● SOURCE pins are electrically quiet for low EMI
● Accurate hysteretic thermal shutdown protection with automatic recovery eliminates need for reset
● Output overvoltage shutdown with optional Zener
● Line undervoltage detect threshold set using a single optional resistor
● Very low component count enhances reliability and enables single-sided printed circuit board layout
● High bandwidth provides fast turn-ON with no overshoot and excellent transient load response
● Extended creepage between DRAIN and all other pins improves field reliability
● Easily meets all global energy efficiency regulations
● No-load <150mW at 265VAC without bias winding, <50mW with bias winding
