● Eight Low-Side Drivers With Internal Clamp for Inductive Loads and Current Limiting for Self Protection
● Seven Outputs Rated at 150 mA and Controlled Through Serial Interface
● One Output Rated at 150 mA and Controlled Through Serial Interface and Dedicated Enable Pin
● 5-V ±5% Regulated Power Supply With 200-mA Load Capability at VIN Max of 18 V
● Internal Voltage Supervisory for Regulated Output
● Serial Communications for Control of Eight Low-Side Drivers
● Enable/Disable Input for OUT1
● 5-V or 3.3-V I/O Tolerant for Interface to Microcontroller
● Programmable Power-On Reset Delay Before RST Asserted High, Once 5 V Is Within Specified Range (6 ms Typ)
● Programmable Deglitch Timer Before RST Is Asserted Low (40 µs Typ)
● Zero-Voltage Detection Signal
● Thermal Shutdown for Self Protection
● APPLICATIONS
● Electrical Appliances
● Air Conditioning Units
● Ranges
● Dishwashers
● Refrigerators
● Microwaves
● Washing Machines
● General-Purpose Interface Circuits, Allowing Microcontroller Interface to Relays, Electric Motors, LEDs, and Buzzers
●PowerPAD is a trademark of Texas Instruments.
●## DESCRIPTION/ORDERING INFORMATION
●The power supply provides regulated 5-V output to power the system microcontroller and drive eight low-side switches. The AC zero-detect circuitry is monitoring the crossover voltage of the mains AC supply. The resultant signal is a low-frequency clock output on the ZVS terminal, based on the AC-line cycle. This information allows the microcontroller to reduce in-rush current by powering loads on the AC-line peak voltage.
●A serial communications interface controls the eight low-side outputs; each output has an internal snubber circuit to absorb the energy in the inductor at turn OFF. Alternatively, the system can use a fly-back diode to VIN to help recirculate the energy in an inductive load at turn OFF.
