The TPS2491DGSG4 is a Retry Positive High Voltage Power-Limiting Hot Swap Controller that safely drive an external N-channel MOSFET switch. The power limit and current limit (both are adjustable and independent of each other) ensure that the external MOSFET operates inside a selected safe operating area (SOA) under the harshest operating conditions. Applications include inrush current limiting, electronic circuit breaker protection, controlled load turn-on, interfacing to down-stream DC-to-DC converters and power feed protection. The TPS2491 is supported by application notes, an evaluation module and a design tool. The falling OUT voltage is the result of M1 and CO currents through the short"s impedance at this time scale. The internal GATE clamp causes the GATE voltage to follow the output voltage down and subsequently limits the negative VDS to 1 to 2V.
● Programmable power limiting and current limiting for complete SOA protection
● Automatic retry
● High-side drive for low-RDS (ON) external N-channel MOSFET
● Programmable fault timer to protect the MOSFET and eliminate nuisance shutdowns
● Power good open-drain output for downstream DC/DC coordination
● Enable can be used as a programmable under-voltage lockout or logic control
● Green product and no Sb/Br
●IC can be damaged by ESD. We recommend that all ICs be handled with appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.