| TYPE | DESCRIPTION |
|---|
| Mounting Style | Surface Mount |
| Number of Pins | 8 Pin |
| Case/Package | DSBGA-8 |
| Number of Outputs | 1 Output |
| Output Voltage | 1.2V ~ 3.3V |
| Output Current | 300 mA |
| Quiescent Current | 300 nA |
| Number of Regulated Outputs | 1 Output |
| Switching Frequency | 1.2 MHz |
| Topology | Buck |
| Input Voltage (Max) | 5.5 V |
| Input Voltage (Min) | 2.15 V |
| Output Current (Max) | 0.3 A |
| Operating Temperature (Max) | 85 ℃ |
| Operating Temperature (Min) | -40 ℃ |
| Input Voltage | 5.5 V |
| TYPE | DESCRIPTION |
|---|
| Product Lifecycle Status | Active |
| Packaging | Tape & Reel (TR) |
| Size-Length | 1.592 m |
| Size-Width | 0.896 mm |
| Size-Height | 0.5 mm |
| Operating Temperature | -40℃ ~ 85℃ (TA) |
The TPS62746 is a high efficiency step down converter with ultra low quiescent current of typical 360 nA. The device is optimized to operate with a 2.2-µH inductor and 10µF output capacitor. The device uses DCS-Control™ and operates with a typical switching frequency of 1.2 MHz. In Power Save Mode the device extends the light load efficiency down to a load current range of 10-µA and below. TPS62746 provides an output current of 100mA. Once started the device operates down to an input voltage range of 2.0 V. This allows to operate the device directly from a single Li-MnO2 coin cell.
●The TPS62746 provides two programmable output voltages of 1.2V and 1.8V selectable by one voltage select pin. The TPS62746 is optimized to provide a low output voltage ripple and low noise using a small output capacitor. Once the input voltage comes close to the output voltage the device enters the No Ripple 100% mode to prevent an increase of output ripple voltage. In this operation mode the device stops switching and turns the high side MOSFET switch on.
●The TPS62746 has an integrated 1-mA switch that connects the supply voltage at pin VIN to the output VINSW. This low current switch that can be used to disconnect a resistor divider from the input supply typically being used to measure the input voltage with an ADC.
TI
Ultra-low-power DC-DC converter with Vin-switch in WCSP 8-DSBGA -40℃ to 85℃
TI
Conv DC-DC 2.15V to 5.5V Step Down Single-Out 1.2V to 3.3V 0.3A 8Pin DSBGA T/R
TI
Conv DC-DC 2.15V to 5.5V Step Down Single-Out 1.2V to 3.3V 0.3A 8Pin DSBGA T/R
TI
TPS62746 DC to DC Converter and Switching Regulator Chip 1.2VDC/3.3VDC Output Evaluation Board
Part Datasheet PDF Search
72,405,303 Parts Datasheet PDF, Update more than 5,000 PDF files ervery day.
