This 8-bit non-inverting translator uses two separate configurable power-supply rails. The A port tracks the VCCA pin supply voltage. The VCCA pin accepts any supply voltage between 1.4 V and 3.6 V. The B port tracks the VCCB pin supply voltage. The VCCB pin accepts any supply voltage between 1.65 V and 5.5 V. Two input supply pins allows for low Voltage bidirectional translation between any of the 1.5 V, 1.8 V, 2.5 V, 3.3 V, and 5 V voltage nodes.
●When the output-enable (OE) input is low, all outputs are placed in the high-impedance (Hi-Z) state.
●To ensure the Hi-Z state during power-up or power-down periods, tie OE to GND through a pull-down resistor. The minimum value of the resistor is determined by the current-sourcing capability of the driver.
● AEC-Q100 Qualified for Automotive Applications
● Device Temperature Grade 1: –40°C to 125°C
● Device HBM ESD Classification Level 2
● Device CDM ESD Classification Level C6
● No Direction-Control Signal Needed
● Maximum Data Rates
● 110 Mbps (Push Pull)
● 1.2 Mbps (Open Drain)
● 1.4 V to 3.6 V on A Port and 1.65 V to 5.5 V on B
●Port (VCCA ≤ VCCB)
● No Power-Supply Sequencing Required – Either
●VCCA or VCCB Can Be Ramped First
● Latch-Up Performance Exceeds 100 mA Per
●JESD 78, Class II
● ESD Protection Exceeds JESD 22 (A Port)
● 2000 V Human Body Model (A114-B)
● 1000 V Charged-Device Model (C101)
● IEC 61000-4-2 ESD (B Port)
● ±8 kV Contact Discharge
● ±6 kV Air-Gap Discharge