LPC2294HBD144/01,5 Datasheet PDF - NXP

The LPC2294HBD144/01,5 is a 16-/32-bit Microcontroller based on ARM7TDMI-S CPU with real-time emulation and embedded trace support. A 128-bit wide memory interface and an unique accelerator architecture enable 32-bit code execution at maximum clock rate. For critical code size applications, the alternative 16-bit Thumb mode reduces code by more than 30 % with minimal performance penalty. The device incorporates 256kB embedded high speed flash, 16kB on-chip SRAM, 8-channel 10-bit A/D converter, advanced CAN channels, three 32-bit timers, PWM channels and 112 general-purpose I/O pins.

● In-system programming (ISP) and In-application programming (IAP)

● EmbeddedICE RT and embedded trace interfaces

● 2/4 Interconnected CAN interfaces with advanced acceptance filters

● Serial interfaces - two UARTs (16C550), fast I2C-bus (400 Kbit/s) and two SPIs

● Two 32-bit timers, PWM unit, real-time clock and watchdog

● Vectored interrupt controller with configurable priorities and vector addresses

● Configurable external memory interface w/up to 4 banks, each up to 16MB and 8/16/32-bit data width

● Up to 112 general purpose I/O pins (5V tolerant)

● Up to nine edge or level sensitive external interrupt pins available

● 60MHz Maximum CPU clock available from programmable on-chip PLL

● On-chip crystal oscillator with an operating range of 1MHz to 25MHz

● Power saving modes include Idle and power-down

● Processor wake-up from power-down mode via external interrupt

● Individual enable/disable of peripheral functions for power optimization