MAX3420EEVKIT-2+ Datasheet PDF - Maxim Integrated

Evaluation kit-2 (EV kit-2) provides a proven design to evaluate the MAX3420E USB peripheral controller with SPI™ interface. The EV kit-2 board is jumper-connected to an Atmel® ATtiny2313 microcontroller by default but can also be connected to any SPI master. The EV kit-2 board comes with the MAX3420EECJ+ installed. The MAX3420E EV kit-2 adds USB functionality to any microcontroller, microprocessor, DSP, CPLD, FPGA, or ASIC with an SPI master interface or five GPIO lines can connect to the MAX3420E EV kit-2.

● Complies with USB 2.0 (full speed)

● Custom USB drivers not required

● USB powered (USB cable included) and USB power LED indicator

● On-board ATtiny2313 microcontroller

● Four GPI port-connected pushbuttons

● Four GPO port LED indicators

● 20 pin signal header to connect the MAX3420E to any microcontroller

● Proven PCB layout

● Fully assembled and tested