The TI MSP family of ultra-low-power microcontrollers consists of several devices that feature different sets of peripherals targeted for various applications. The architecture, combined with five low-power modes, is optimized to achieve extended battery life in portable measurement applications. The device features a powerful 16-bit RISC CPU, 16-bit registers, and constant generators that contribute to maximum code efficiency. The digitally controlled oscillator (DCO) allows the device to wake up from low-power modes to active mode in less than 1 µs.
●The MSP430G2x03 and MSP430G2x33 devices are ultra-low-power mixed-signal microcontrollers with built-in 16-bit timers, up to 24 I/O capacitive-touch enabled pins, and built-in communication capability using the USCI. In addition, the MSP430G2x33 family members have a 10-bit ADC. See for configuration details.
●Typical applications include low-cost sensor systems that capture analog signals, convert them to digital values, and then process the data for display or for transmission to a host system.
● Low Supply-Voltage Range: 1.8 V to 3.6 V
● Ultra-Low Power Consumption
● Active Mode: 230 µA at 1 MHz, 2.2 V
● Standby Mode: 0.5 µA
● Off Mode (RAM Retention): 0.1 µA
● Five Power-Saving Modes
● Ultra-Fast Wake up From Standby Mode in Less Than 1 µs
● 16-Bit RISC Architecture, 62.5-ns Instruction Cycle Time
● Basic Clock Module Configurations
● Internal Frequencies up to 16 MHz With Four Calibrated Frequencies
● Internal Very-Low-Power Low-Frequency (LF) Oscillator
● 32-kHz Crystal
● External Digital Clock Source
● Two 16-Bit Timer_A With Three Capture/Compare Registers
● Up to 24 Capacitive-Touch Enabled I/O Pins
● Universal Serial Communication Interface (USCI)
● Enhanced UART Supports Automatic Baud-Rate Detection (LIN)
● IrDA Encoder and Decoder
● Synchronous SPI
● I2C
● 10-Bit 200-ksps Analog-to-Digital Converter (ADC) With Internal Reference, Sample-and-Hold, and Autoscan (See )
● Brownout Detector
● Serial Onboard Programming,
●No External Programming Voltage Needed,
●Programmable Code Protection by Security Fuse
● On-Chip Emulation Logic With Spy-Bi-Wire Interface
● Summarizes Available Family Members
● Package Options
● TSSOP: 20 Pin, 28 Pin
● PDIP: 20 Pin
● QFN: 32 Pin
