SC18IS602BIPW/S8HP Datasheet PDF - NXP

Overview

●The SC18IS600 is designed to serve as an interface between the standard SPI of a host (microcontroller, microprocessor, chip set, etc.) and the serial I²C-bus. This allows the host to communicate directly with other I²C-bus devices. The SC18IS600 can operate as an I²C-bus master-transmitter or master-receiver. The SC18IS600 controls all the I²C-bus specific sequences, protocol, arbitration and timing.

●MoreLess

●## Features

● SPI slave interface

● SPI Mode 3

● Single master I²C-bus controller

● Four General Purpose Input/Output (GPIO) pins

● Two quasi-bidirectional I/O pins

● 5 V tolerant I/O pins

● High-speed SPI: Up to 1.2 Mbit/s

● High-speed I²C-bus: 400 kbit/s

● 96-byte transmit buffer

● 96-byte receive buffer

● 2.4 V to 3.6 V operation

● Power-down mode with WAKEUP pin

● Internal oscillator

● Active LOW interrupt output

● Available in very small TSSOP16 and HVQFN24 packages

●## Features