This 32-bit noninverting bus transceiver is designed for 1.65-V to 3.6-V VCC operation.
●The SN74LVC32245 is designed for asynchronous communication between data buses. The control-function implementation minimizes external timing requirements.
●This device can be used as four 8-bit transceivers, two 16-bit transceivers, or one 32-bit transceiver. It allows data transmission from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE)\ input can be used to disable the device so that the buses are effectively isolated.
●Inputs can be driven from either 3.3-V or 5-V devices. This feature allows the use of these devices as translators in a mixed 3.3-V/5-V system environment.
●This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down.
●To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
● Member of the Texas Instruments Widebus+ Family
● Operate From 1.65 V to 3.6 V
● Inputs Accept Voltages to 5.5 V
● Max tpd of 4 ns at 3.3 V
● Typical VOLP (Output Ground Bounce)
● <0.8 V at VCC = 3.3 V, TA= 25°C
● Typical VOHV (Output VOH Undershoot)
● >2 V at VCC = 3.3 V, TA = 25°C
● Ioff Supports Partial-Power-Down Mode Operation
● Support Mixed-Mode Signal Operation on All Ports (5-V Input/Output Voltage With 3.3-V VCC)
●Widebus+ is a trademark of Texas Instruments.
