INTRODUCTION
●The ST7558 is a driver & controller LSI for graphic dot-matrix liquid crystal display systems. It contains 102 segment and 65 common with 1 ICOM driver circuits. This chip is connected directly to a microprocessor, accepts 4-line serial nterface (SPI), I2C interface or 8-bit parallel interface, display data can stores in an on-chip display data RAM of 66 x 102 bits. It performs display data RAM read/write operation with no external operating clock to minimize power consumption. In addition, because it contains power supply circuits to drive liquid crystal, it is possible to make a display system with the fewest components.
●FEATURES
●Driver Output Circuits
●102 segment outputs / 65 common outputs
●On-chip Display Data Ram
● - Capacity: 66X102=6732 bits
●Microprocessor Interface
● - 8-bit parallel bi-directional interface with 6800-series or 8080-series
● - 4-line SPI (serial peripheral interface) available (only write operation)
● - I2C (Inter-Integrated Circuit) Interface
●On-chip Low Power Analog Circuit
● - Generation of LCD supply voltage (externally Vout voltage supply is possible)
● - Generation of intermediate LCD bias voltages
● - Oscillator requires no external components (external clock also possible)
● - Voltage converter (x2, x3, x4, x5)
● - Voltage regulator (temperature gradient -0.05%/°C)
● - Voltage follower
● - On-chip electronic contrast control function (128 stepsX2)
● - Liquid crystal driving voltage :
●V0 -VSS = max 12 V (external power supply)
●External RESB (reset) pin
●Logic supply voltage range VDD -VSS
● - 1.8 to 3.3V
●Temperature range: -30 to +85 degree
