The TLK100 is a single-port Ethernet PHY for 10BaseT and 100Base TX signaling. It integrates all the physical-layer functions needed to transmit and receive data on standard twisted-pair cables. This device supports the standard Media Independent Interface (MII) for direct connection to a Media Access Controller (MAC).
●The TLK100 is designed for power-supply flexibility, and can operate with a single 3.3V power supply or with combinations of 3.3V, 1.8V, and 1.1V power supplies for reduced power operation.
●The TLK100 uses mixed-signal processing to perform equalization, data recovery, and error correction to achieve robust operation over CAT 5 twisted-pair wiring. It not only meets the requirements of IEEE 802.3, but maintains high margins in terms of cross-talk and alien noise.
● Temperature From 40°C to 85°C
● Low Power Consumption, < 200mW Typical
● Cable Diagnostics
● Error-Free Operation up to 200 Meters Under Typical Conditions
● 3.3V MAC Interface
● Auto-MDIX for 10/100 Mb/s
● Energy Detection Mode
● 25 MHz Clock Out
● MII Serial Management Interface (MDC and MDIO)
● IEEE 802.3u MII
● IEEE 802.3u Auto-Negotiation and Parallel Detection
● IEEE 802.3u ENDEC, 10BASE-T Transceivers and Filters
● Bus I/O Protection - ±16kV JEDEC HBM
● IEEE 802.3u PCS, 100BASE-TX Transceivers
● Enables IEEE1588 Time-Stamping
● IEEE 1149.1 JTAG
● Integrated ANSI X3.263 Compliant TP-PMD Physical Sublayer with
●Adaptive Equalization and Baseline Wander Compensation
● Programmable LED Support Link, 10/100 Mb/s Mode, Activity,
●and Collision Detect
● 10/100 Mb/s Packet BIST (Built in Self Test)
● 48-pin TQFP Package (7mm) × (7mm)
● Applications
● Industrial Controls and Factory Automation
● General Embedded Applications
