The TPS3860x0 family of supply voltage supervisors (SVSs) can monitor four power rails that are greater than 0.4 V and one power rail less than 0.4 V (including negative voltage) with a 0.25% (typical) threshold accuracy. Each of the four supervisory circuits (SVS-n) assert a RESETn or RESETn output signal when the SENSEm input voltage drops below the programmed threshold. With external resistors, the threshold of each SVS-n can be programmed (where _n_ = 1, 2, 3, 4 and _m_ = 1, 2, 3, 4L, 4H).
●Each SVS-n has a programmable delay before releasing RESETn or RESETn. The delay time can be set independently for each SVS from 1.4 ms to 10 s through the CTn pin connection. Only SVS-1 has an active-low manual reset (MR) input; a logic-low input to MR asserts RESET1 or RESET1.
●SVS-4 monitors the threshold window using two comparators. The extra comparator can be configured as a fifth SVS to monitor negative voltage with voltage reference output VREF.
●The TPS3860x0 has a very low quiescent current of 11 µA (typical) and is available in a small, 4-mm × 4-mm, VQFN-20 package.
● Four Independent Voltage Supervisors
● Channel 1:
● Adjustable Threshold Down to 0.4 V
● Manual Reset (MR) Input
● Channels 2, 3:
● Adjustable Threshold Down to 0.4 V
● Channel 4:
● Adjustable Threshold at Any Positive or
●Negative Voltage
● Window Comparator
● Adjustable Delay Time: 1.4 ms to 10 s
● Threshold Accuracy: 0.25% Typical
● Very Low Quiescent Current: 11 µA Typical
● Watchdog Timer With Dedicated Output
● Well-Controlled Output During Power Up
● TPS386000: Open-Drain RESETn and WDO
● TPS386040: Push-Pull RESETn and WDO
● Package: 4-mm × 4-mm, 20-Pin VQFN
