The TPS54362 is a step down switch mode power supply with voltage supervisor. Integrated input voltage line feed forward topology improves line transient regulation of the voltage mode buck regulator. The regulator has a cycle-by cycle current limit. A pulse skip mode operation under no load reduces the supply current to 65 µA. Using the enable pin, the supply shutdown current is reduced to 1 µA.
●An open drain reset signal indicates when the nominal output drops below the threshold set by an external resistor divider network. The output voltage start up ramp is controlled by a soft start capacitor. There is an internal undervoltage shut down which is activated when the input supply ramps down to 2.6 V.
● Withstands Transients up to 60 V With an Operating Range of 3.6 V to 48 V
● Asynchronous Switch Mode Regulator With External Components (L and C),
●Load Current up to 1 A (Maximum)
● 0.8 V ±1.5% Voltage Reference
● 200-kHz to 2.2-MHz Switching Frequency
● High Voltage Tolerant Enable Input for ON/OFF State
● Soft Start on Enable Cycle
● Slew Rate Control on Internal Power Switch
● External Clock Input for Synchronization
● Pulse Skip Mode (PFM) During Light Output Loads With Quiescent
●Current = 65 µA Typical (LPM Operation)
● External Compensation for Wide Bandwidth Error Amplifier
● Internal Undervoltage Lock Out UVLO
● Programmable Reset Power on Delay
● Reset Function Filter Time for Fast Negative Transients
● Programmable Overvoltage Output Monitoring
● Programmable Undervoltage Output Monitoring, Issuance of Reset if
●Output Falls Below Threshold
● Switch Current Limit Protection
● Short Circuit and Overcurrent Protection of FET
● Package: 20-pin HTSSOP PowerPAD