Part Datasheet Search > Interface ICs > FTDI Chip > FT4232HL Datasheet PDF > FT4232HL Datasheet Pages 12/45
FT4232HL Datasheet - FTDI Chip
| Manufacturer: | FTDI Chip |
| Category: | Interface ICs |
| Case Package: | LQFP-64 |
| Description: | USB Hi-Speed to Quad Channel Serial UART/JTAG/SPI/I2C IC - LQFP-64 |
| Pictures: |
FT4232HLDatasheet PDF
Page:
of 45 Go
If the format of the manual is confusing, please download and read the original PDF file.
Copyright © 2010 Future Technology Devices International Limited 12
Document No.: FT_000060
FT4232H QUAD HIGH SPEED USB TO MULTIPURPOSE UART/MPSSE IC
Datasheet Version 2.2
Clearance No.: FTDI#78
3.4 Configured Pins
The following sections describe the function of the configurable pins referred to in Table 3.1 which is
determined by how the FT4232H is configured.
3.4.1 FT4232H pins used as an asynchronous serial interface
The FT4232H any of the 4 channels can be configured as an asynchronous serial UART interface
(RS232/422/485). When configured in this mode, the pins used and the descriptions of the signals are
shown in Table 3.5.
Channel
A
Pin No.
Channel
B
Pin No.
Channel
C
Pin No.
Channel
D
Pin No.
Name
Type
RS232 Configuration Description
16
26
38
48
TXD
OUTPUT
TXD = transmitter output
17
27
39
52
RXD
INPUT
RXD = receiver input
18
28
40
53
RTS#
OUTPUT
RTS# = Ready To send handshake
output
19
29
41
54
CTS#
INPUT
CTS# = Clear To Send handshake input
21
30
43
55
DTR#
OUTPUT
DTR# = Data Transmit Ready modem
signaling line
22
32
44
57
DSR#
INPUT
DSR# = Data Set Ready modem
signaling line
23
33
45
58
DCD#
INPUT
DCD# = Data Carrier Detect modem
signaling line
24
34
46
59
RI#/
TXDEN
INPUT/OUTPUT
RI# = Ring Indicator Control Input.
When the Remote Wake up option is
enabled in the EEPROM, taking RI# low
can be used to resume the PC USB Host
controller from suspend.
(see note 1, 2 and 3)
TXDEN = (TTL level). For use with RS485
level converters.
Table 3.5 Channel A,B,C and Channel D Asynchronous Serial Interface Configured Pin Descriptions
Notes
1. When using remote wake-up, ensure the resistors are pulled-up in suspend. Also ensure
peripheral designs do not allow any current sink paths that may partially power the peripheral.
2. If remote wake-up is enabled, a peripheral is allowed to draw up to 2.5mA in suspend. If remote
wake-up is disabled, the peripheral must draw no more than 500uA in suspend.
3. If a Pull-down is enabled, the 4232H will not wake up from suspend.
Part Datasheet PDF Search
72,405,303 Parts Datasheet PDF, Update more than 5,000 PDF files ervery day.