● Supply Voltage Range 2.2 V to 3.6 V
● 16-Bit RISC Architecture, up to 16.384-MHz System Clock
● Power Consumption
● Active Mode (AM): All System Clocks Active 275 µA/MHz at 16.384-MHz, 3.0 V, Flash Program Execution (Typical)
● Standby Mode (LPM3): Watchdog Timer Active, Full RAM Retention 210 µA at 3.0 V (Typical)
● Off Mode (LPM4): Full RAM Retention 70 µA at 3.0 V (Typical)
● Shutdown Mode (LPM4.5): 75 nA at 3.0 V (Typical)
● Wake Up From Standby Mode in 1 µs
● Memories
● Up to 32KB of Flash Main Memory
● 1KB of Flash Information Memory
● Up to of 2KB of RAM
● Power Management System
● Integrated LDO With 1.8-V Regulated Core Supply Voltage
● Supply Voltage Monitor With Programmable Level Detection
● Brownout Detector
● Built-in Voltage Reference
● Temperature Sensor
● Clock System
● 16.384-MHz Internal DCO
● DCO Operation With Internal or External Resistor
● External Digital Clock Source
● Up to Four 24-Bit Sigma-Delta Analog-to-Digital Converters (ADCs) With Differential PGA Inputs
● Two 16-Bit Timers With Three Capture/Compare Registers Each
● Enhanced Universal Serial Communication Interfaces (eUSCIs)
● eUSCI_A0
● Enhanced UART With Automatic Baud-Rate Detection
● IrDA Encoder and Decoder
● Synchronous SPI
● eUSCI_B0
● Synchronous SPI
● I2C
● 16-Bit Hardware Multiplier
● Serial Onboard Programming, No External Programming Voltage Needed
● Programmable Code Protection
● On-Chip Emulation Module
● Available in 28-Pin TSSOP (PW) and 32-Pin VQFN (RHB) Packages
